NIC Clamp-On Sensor

Clamp-on ultrasonic flow meter is ideal for retrofitting system at flow measurement places as well as for monitoring of water networks. Unaffected by pressure and temperature.

Enquire Now

Measures: Flow

Industries: Data Centre, Discharge Licence Compliance, Environmental Monitoring, Pharma, Utilities, Wastewater, Water

Measure. Monitor. Repeat.

For better insights, better decision-making and better process performance.

Key Features & Benefits

Non-contact clamp-on ultrasonic measurement
Suitable for clean to polluted media
Designed for full pipes with various dimensions
No contact with the measurement medium, making it ideal for drinking water applications
Quick and easy installation with minimal effort
Suitable for high-pressure applications
Suitable for aggressive and abrasive media
Uses the ultrasonic transit time principle
Provides high-accuracy flow measurement
Ideal for retrofitting existing systems
Suitable as a replacement for existing flow measurement systems
Includes matched mounting materials for reliable installation
Supports continuous flow measurement and data storage

Typical clamp-on sensor applications

Fixed measurements in full pipes in hydropower plants, pump stations and similar
Monitoring of drinking water plants and networks
Irrigation systems
Inlets and outlets conducting cooling water or circulation
WWTP outlets
Dirty water pipelines
Industrial flow measurements, process water
Retrofitting and Replacement of existing flow measurement system
and many more

Product Description
Technical Data
Videos & Downloads

Clamp-on ultrasonic flow meter sensors are part of a measurement system for continuous flow measurement and storage of the recorded measurement data. They can be used for clean to polluted media.

The sensors of this non contact flow meter are used for flow measurement in full pipes featuring various dimensions.

Thanks to the clamp-on design there is no contact between sensor and the measurement medium. The sensors therefore are particularly suitable for use in the drinking water area. Measurement tasks can be carried out very easy within very short time without any greater effort. This applies for high pressures as well as for aggressive and abrasive media.

Readings are detected based on the ultrasonic transit time principle, which allows versatile use with high accurate measurement results. Thanks to perfectly matched mounting material the system is ideal for retrofitting or as replacement system for existing flow measurements.

Measurement principle	Ultrasonic transit time difference as contactless sensors
Material	PEEK and stainless steel 1.4301/AISI 304 Other materials upon request
Measurement frequency	1 MHz, 500 kHz
Velocity range	±25 m/s (minimum flow velocity: 0.01 m/s)
Internal Pipe Diameter	0.05…6.00 m (DN50 – DN6000) NIC-CO01: DN50 – DN2500 NIC-CO50: DN300 – DN6000
Protection	IP 68
Ex-Approval	ATEX / IECEx Zone 1 (optional)
Operating temperature	−40 °C ≤ Ta ≤ +80 °C
Storage temperature	−40 °C to +80 °C (non-condensing)
Cable lengths	7/10/20/30/40/50 m
Accuracy	Volume flow (Q): ±0.5 % of measured value with process calibration